The MacTwister breakout board provides a standard RJ45 to Macintosh SE and Macintosh SE/30 computers equipped with common Asante MacCon, Kinetics/Shiva Etherport and Dayna Daynaport E/SI cards.

The first motivation is that many of those cards got separated from their breakout boards over the course of >30 years, making them virtually useless. On the other hand, the network card prices are going up and a project to reproduce the connector board starts to make economical sense. I myself came across a MacCon for SE which I really wanted to bring back to life.

The second motivation is that most of the connector cards only offer AUI and BNC (10BASE2) connectors, requiring an external box (such as CentreCOM AT-210T) that sticks out and doesn’t look too cool. Maybe I’m unlucky, but none of the cards I own actually came with a twisted pair interface.

Goals of the design:

• Support most common cards for SE and SE/30: MacCon, Etherport and Dayna.
• Support a number of transceiver chips to avoid being locked into a single no-longer-produced model, preferably without component changes.
• Use modern components (eg. an RJ45 jack with magnetics) to avoid sourcing anything exotic apart from transceivers.

Questions & Answers

What’s the deal with two 16-pin connectors?

Kinetics/Shiva Etherport and MacCon cards have different pinouts of the 16-pin cable to the connector card.

Please be extra careful about using the right connector for your card. Please be extra careful about correctly orienting the plug in the socket (mind the Pin 1 markings). Note that MacCon cards do not use the common Pin 1 convention of the IDC connectors.

Kinetics Etherport SE. Note that the pin 1 marking (P1) matches the red conductor on the IDC tape.

Asant MacCon. The pin 1 on the PCB (square pad) does not match the pin 1 on the IDC tape.

MacTwister connected to the early revision of MaCon. Please note the Pin1 markings in the picture. On MacCon, the PCB suggests Pin1 is actually on the other side, ignore it.

Both 16-pin connectors can be used without any changes to the board.

What’s the deal with three different sockets for transceiver ICs?

This board depends on No-Longer-Available AUI to Twisted Pair converters. Those transceivers has not been in production since decades so this design incorporates three different chips to let you pick a chip that actually shows up on the market: LXT902PC, AM79C89 or T7220 / T7220A.

The same MacTwister design working with three different transceivers: from left to right T7220, LXT902PC and AM79C89.